Lighting Control Systems : Dimmers & Dimmer Systems : Crestron Electronics, Inc. - ZUMLINK-JBOX-20A-PLUG

Zum Wired J-Box Load Controller, Plug Load Switch, 20A, 100-240V with Link Communication

Model: ZUMLINK-JBOX-20A-PLUG

Zum® wired junction box-mounted lighting load plug load controller
Integration with Zum keypads, occupancy sensors, vacancy sensors, and daylight sensors (sold separately)
Zero cross switch control of 20A, 100-250V plug loads
Supports in-room device daisy chaining
Integrated contact closure input

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

The Crestron Zum® Wired ZUMLINK-JBOX-20A-PLUG provides zero cross switching for high inrush lighting loads and 20A plug load control. The device can be wired to other in-room Zum devices to provide load control. Energy-saving options are available to enable daylighting, occupancy or vacancy sensing, and centralized monitoring and management.

Zum Link Wired Technology

Zum Link technology allows for in-room lighting control through compatible keypads and sensors. Two RJ-45 ports on the device allow for connection to a Zum Net device and for in-room device daisy-chaining. Similar to the Zum Wireless system, Zum Link devices work together in a local ecosystem to provide customized solutions as needed.

Easy Installation

For flexibility and ease-of-use, Zum load controllers are installed in a room with Zum keypads, occupancy or vacancy sensors, and/or a daylight sensor for complete commercial lighting control. Finish the installation by quickly commissioning the room through the Zum app.

Override Contact Closure Input

An integrated contact closure input or relay output on the ZUMLINK-JBOX-20A-PLUG provides the means to place all connected Zum Net and Zum Link devices into Emergency Override mode.

Zum® wired junction box-mounted lighting load plug load controller
Integration with Zum keypads, occupancy sensors, vacancy sensors, and daylight sensors (sold separately)
Zero cross switch control of 20A, 100-250V plug loads
Supports in-room device daisy chaining
Integrated contact closure input
Flying lead wiring connections
Knockout mount to a standard 4 in. square junction box

Spec Sheet available - Yes

Certifications: IC, FCC, cUL, UL
Operating Temperature (Maximum): 104 F
Operating Temperature (Minimum): 32 F
AC Voltage (Minimum): 100 Volts
AC Voltage (Maximum): 240 Volts
Current Draw: 20 Amps
Depth: 2.03 in
Height: 4.83 in
Width: 4.25 in
Product Weight: 0.20 lbs
Load Control:
•Switch Load Types: Controlled receptacles, LED, electronic ballasts, incandescent, magnetic lowvoltage, electronic low-voltage,neon/cold cathode, high-intensity discharge, small motor loads
•Load Rating: 20A 100-277VAC, 50/60 Hz high inrush, zero cross switching; 0.5 HP at 120-277VAC
•Short Circuit Protection: 40A non-replaceable fuse
Wired Communications:
•ZUMLINK (ROOM): (2) RJ-45 ports; In-room Zum Link device daisy-chaining; 85mA power available for Zum Link devices, including ZUMLINK-KP keypads
•24V, OCC, GND: Occupancy sensor input; 85mA available output current; Spring clamp connector
•24V, PHO, GND: Photo sensor input; Spring clamp connector
•OVR, GND: Override control input; Spring clamp connector
Controls and Indicators:
•TEST: (1) Pushbutton and (1) green LED; Push to toggle the switched load output on and off; Press and hold to cycle the dimming level up and down; LED indicates that the load is turned on; LED lights and flashes during room setup and factory reset
•ZUMLINK Status: (1) bi-color green/red LED; LED lights green in normal operation; LED lights red when a fault is detected
Connections:
•Hot: (1) 14 AWG Class 1 flying lead; Black, line power input
•Neutral: (1) 14 AWG Class 1 flying lead; White, neutral
•Red: (1) 14 AWG Class 1 flying lead, red, AC output
Humidity: 10% to 90% RH (noncondensing)
Construction:
•Housing: Plastic, white, UL 94 5VA flame rated
•Mounting: Mounts to the side of a 4 in. square junction box via a 1/2 in. conduit knockout; Meets the requirements of UL 2043 for installation in an environmental air-handling (plenum) space

Load Controller 2517365 kb - Data Sheet

Project List

Find a Dealer

Suggested Products

GE In-Wall Toggle Dimmer Works with Ring Alarm Security System

by Ring

GE Plug-In Dimmer (Two Outlet) Works with Ring Alarm Security System

by Ring