Z-Wave Touch Panel Switch, 1-5 channels. With advanced zero-cross technology, dry contacts and 5A load for each channel. For lights, door locks, valves, and motorized devices control. Compatible with: Aeotec, ComfortClick, Eedomus, Ezlo, Fibaro HC LITE, HC2, HC3, Jeedom, Home Assistant, Homey, Hubitat, RazBerry, SmartThings, Thinka, Zipato gateways and Z-Wave JS library.
The Touch Panel Switch is available in 30 combinations to integrate seamlessly with your interior design. Five frames (silver, chrome, gloss black, matte black, & white), and six glass colours (white, black, yellow, green, red and blue) let you match any environment, style, or taste.
Designed to be powerful, efficient and stylish, at 9 mm thick the Touch Panel Switch is ‘Impossibly Thin’ and good-looking on your wall.
HELTUN Touch Panel Switches include sensors to monitor temperature, humidity, and ambient light which can be accessed by a Z-Wave controller and used to trigger home automation scenes.
The frequency (reporting time) of data updates from sensors can be individually adjusted to meet the needs of your smart home system.
HELTUN Touch Panel Switches can be easily installed into any standard electrical junction box (square or round).
Installation must only be performed by someone trained in handling high voltage electrical systems.
- Inclusion/exclusion into/from Z-wave network
- Non Secure,
- S0 secure,
- S2 unauthorized,
- S2 authorized
- Association control of Z-Wave devices in the network
- Independent control of each relays and LEDs
- Each relay can be controlled by any touch button or via a Z-Wave network (Z-Wave controller).
- Each touch button can be configured to control any relay (from one and up to five) output state in below modes:
- press the button and the relay output goes to ON state only
- press the button and the relay output goes to OFF state only
- press the button and the relay output inverts the state
- press the button and the relay output goes to ON for thespecified time then changes back to OFF.
- press the button and the relay output goes to OFF for the specified time then changes back to ON.
- When the button is held the relay output is ON, as soon asthe button is released the relay output state changes to OFF.
- When the button is held the relay output is OFF, as soon asthe button is released the relay output state changes to ON.
- Each touch buttons can be used to run scenarios
- Each button backlight can be configured
- To indicate the relay output state
- To indicate the touch button state
- To indicate some mode state in the connected gateway
- To indicate the associated device state
- Software energy consumption meter logic
- Consumption meter reset
- Temperature sensors calibration
- Adjustable backlight brightness: Auto or Manual
- Factory reset
- OTA function (Firmware update over the air).
